Setting Motion Detection - Honeywell ACUIX User Manual

Setting Motion Detection

Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Note WDR is disabled when the auto slow shutter limit is reached or when
the camera enters NightShot mode. It cannot be enabled while auto
slow shutter and/or NightShot are on.
To enable/disable wide dynamic range:
• Select 5 Camera Options

Dynamic Range
This feature is only available with HDXJ and HDXF cameras. It is not available with
HDXA cameras.
When motion detection is enabled, any detected motion causes the message
Motion Detected
to be displayed on the monitor. The message remains on the
screen until the dome receives a pan, tilt, or zoom command.
Motion detection is automatically disabled as soon as motion is detected to
avoid multiple triggers from the same event. It is turned on again after a one
minute delay.
Pan, tilt, or zoom changes will disable motion detection.
Note If the dome is configured for IntelliBus protocol, for each motion
detect event an IntelliBus motion detect message is sent to the
IntelliBus master.
To enable/disable motion detection:
• Select 5 Camera Options

Detection ON or OFF (default).
If ON is selected, the message

9 WDR & Motion Detection
ON or OFF (default).

9 WDR & Motion Detection
Motion Detection Enabled

1 Wide

2 Motion
appears.
37