Figure C-6 Ae Control Menu And Example Settings; Table C-2 Auto Exposure Control Mode Settings - Honeywell ACUIX User Manual

Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Figure C-6 AE Control Menu and Example Settings
PROGRAM AE CONTROL MENU
Auto Exp OFF for Manual AE
1 Auto AE Mode............AE
2 NA
3 NA
AE Exp. Mode Features
NightShot Control........MAN
Auto NS Sensitivity.......NA
Digital Slow Shutter.....OFF
Note the following about using NightShot with a 35× camera block.
• AER+1 mode is optimized for signal-to-noise (S/N) ratio priority.
• AER+3 mode is optimized for color priority.
• AER+2 mode is balanced between S/N ratio and color priorities.
• To see a depiction of the approximate light levels where the camera
switches from day mode (IR cut filter in) to night mode (IR cut filter out) and
then from night mode to day mode, see
• Figure C-7 for when the digital slow shutter function is inactive.
• Figure C-8 for when the digital slow shutter function is active.
• The conditions for the change from day to night mode must be
continuously present for more than 5.0 s for the switch to take place.
• The conditions for the change from night to day mode must be
continuously present for more than 8.0 s for the switch to take place.
The exposure mode is toggled between auto and manual using preset 92 if the
ACUIX is configured for MAXPRO-mode, Diamond protocol, VCL protocol, VCL
UTC protocol, Pelco P protocol, or Pelco D protocol. If the camera is in manual
exposure control mode preset 94 toggles between day and night NightShot
(TDN) modes.
Table C-2 Auto Exposure Control Mode Settings
Setting
Auto AE Mode
Auto AER1 Mode
Auto AER2 Mode
Auto AE+ Mode
Auto AER+1 Mode
Auto AER+2 Mode
Auto AER+3 Mode
NightShot Auto
Control NightShot
Sensitivity
MAN NA
AUTO HIGH
AUTO MID
MAN NA
AUTO HIGH
AUTO MID
AUTO LOW
Digital Slow
Shutter
OFF
OFF
OFF
AUTO
AUTO
AUTO
AUTO
105