Charger Specifications; Microdock Ii Automatic Test And Calibration Station - Honeywell MicroDock II Operating Manual

USB Port
Sensors
LCD
Warranty

Charger Specifications

Size
Weight
Charger System Ingress Protection
Operating Temperature
Humidity
Altitude
Power
Charging LED
Charge Time
This device complies with the FCC Part 15 and ICES-003 Canadian EMI requirements.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules and ICES-003 Canadian EMI requirements.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his/her own expense.
WArNINg
This product is designed for installation in an indoor location only. All required National
Electrical Codes and Safety Standards must be followed.
For AC main installation, a circuit breaker should be included in the building installation
as a disconnect device for the equipment. The disconnect device should be installed in
close proximity to the equipment and the device should be marked as a disconnecting
means for the equipment.
66
For connection to a Personal computer (PC), or
USB over IP HUB
Audio Optical
4 line x 16 characters, wide viewing angle, user
selectable backlighting
2 years
8.6 x 8.2 x 7.8 cm (3.4 x 3.2 x 3.1 in.)
97 g (3.4 oz)
IP20
10°C to 35°C (50°F to 95°F)
0% to 50%
2000 m (6561.66 ft.)
6 VDC
Color-coded LED advises: charging,
charge complete, and charger fault.
Typically 2.5 hours

MicroDock II Automatic Test and Calibration Station

, 2.5 A