Inlet Select - Honeywell MicroDock II Operating Manual

If No is selected, the LCD automatically returns to the user options screen. If there
is a problem with the card, the following screen displays.
Press OK to acknowledge and insert a new card and repeat the procedures.
7. Press
Or
Press
For additional information about the MMC card, refer to

Inlet Select

NOTe
Applicable only to custom and multi-gas types.
The Inlet Sel option is used to enable either the automatic (auto) or manual (manu)
function for selecting an inlet.
If the auto option is enabled, the station automatically selects the correct gas inlet
for the bump check or calibration.
If manu is enabled, the applicable test gas must be selected each time a bump/
calibration is performed. If the manu option is enabled, refer to
Applied for Bump Checks and Calibrations
To enable either the auto or manu option, complete the following:
1. From the user options menu, press
option.
2. Press
3. Press
4. When the desired option displays, press
deactivate the field (* changes back to :).
5. Press
Or
Press
MicroDock II Automatic Test and Calibration Station
or ^ to scroll to another user option.
exit to return to the normal operating screen.
sel to confirm the selection and activate the field (: changes to *).
or ^ to toggle between the auto and manu option.
or ^ to scroll to another user option.
exit to return to the normal operating screen.
Base Station MMC
for important information.
or ^ to scroll to the Inlet Sel
sel to confirm the selection and
Card.
Order of Gases
35