Honeywell MicroDock II Operating Manual page 60

Problem
The station is activated but does
not respond to button presses.
There is no audible beep (X5). Internal damage to battery or
The docking module does not
recognize the detector.
There is an audible beep but no
charge (X5 docking modules).
The charger LED does not light
when the detector is inserted
(X5 docking modules.)
60
Possible Cause
Irregular power (not continuous
or reliable) electrostatic
discharge.
docking module.
Detector is deactivated.
Detector does not have IR
communication capabilities.
Fir mware of the detector
requires an update.
Station is currently attempting
to establish communication with
the detector.
Docking module is not initialized
to the correct number.
Detector and/or station are
damaged or defective.
Battery is above or below the
operating temperature 50°F-
95°F (10°C-35°C).
Severely depleted battery.
Damaged or defective battery
pack.
Detector is not inserted into the
detector bay correctly.
The battery pack is above or
below the operating temperature
50°F-95°F (10°C-35°C).
The battery pack is severely
depleted.
Table 20. Troubleshooting Tips
MicroDock II Automatic Test and Calibration Station
Solution
Deactivate the station, wait 5
seconds, then reactivate.
Call for Service.
Activate the detector.
Refer to the label located on
the back of the detector for IR
capabilities.
Call for Service.
Wa i t a p p r o x i m a t e l y 3 0
seconds.
Re-initialize the docking module
- refer to
Adding Another
Docking Module.
Call for Service.
Allow the battery pack time to
adjust to the specified operating
temperature (approximately 60
minutes).
Charge (2-4 hours) or replace
old battery with new battery.
If problem persists, Call for
Service
Call for Service.
Firmly insert the detector into
the detector docking bay.
Allow the battery pack time to
adjust to the specified operating
temperature (approximately 60
minutes).
Allow the detector to charge
(2-4 hours).