Base Station Mmc Card; Event Logging; Inserting/Replacing A Mmc Card - Honeywell MicroDock II Operating Manual

When the datalog has successfully transferred from the station to the MMC card,
the following screen displays.
4. On the station, press
NOTe
A maximum of ten data logs from all modules combined can be stored on
an MMC card. When the maximum storage is reached, the station replaces
the oldest datalogs with the newest datalogs. Datalogs are not recorded
in the Results History.

Base Station MMC Card

Event Logging

Bump checks and calibrations are recorded on a Multi-media card (MMC). The MMC
card is located on the station inside the battery compartment. It is used to store test
records that are then downloaded from the station to a PC.

Inserting/Replacing a MMC Card

The MMC card is inserted in the station inside the battery compartment. To insert or
replace the MMC card, refer to Figure 14 and complete the following procedures:
1. Deactivate the station.
2. Loosen, the retaining screws from the battery cover.
3. Remove the battery cover and set it aside.
4. Remove the current MMC card (if applicable).
5. Insert the new MMC card into the memory card slot.
6. Replace the battery cover and tighten the retaining screws.
Data that is saved on the MMC card can be transferred to a PC.
To format an MMC card, refer to
section.
The transferred data is then compiled using a computer software application called
Fleet Manager II. Refer to the Fleet Manager II Deluxe CD for installation and user
instructions.
56
Pass to return to the normal operating screen.
Figure 14. Replacing a MMC Card
Format the MMC Card
MicroDock II Automatic Test and Calibration Station
in the User Options Menu