Using The Base Station; Activating The Station - Honeywell BW MicroDock II Quick Reference Manual

MicroDock II
Quick Reference Guide
• When the detector has been inserted correctly, the RUN
LEDs on the docking module light yellow and Unit
Inserted displays on the base station LCD. The base
station LCD displays the docking module number, and
the type and serial number of the detector.
GasAlertQuattro
Important: If the GasAlertQuattro is fitted with a calibration cap
or an auxiliary filter, it must be removed prior to inserting it into
the docking module. Refer to the GasAlertQuattro Technical
Reference Guide and the MicroDock II Base Station User Man-
ual. To charge the battery pack separately, refer to the Micro-
Dock II Base Station User Manual.
• Insert the bottom of the detector (LCD facing up) at a
30° angle into the detector bay.
• Close the lid and press until the release tabs click.
• When the detector has been inserted correctly, the RUN
LEDs on the docking module light yellow, Unit Inserted
displays on the base station LCD, and MicroDock II dis-
plays on the detector LCD. The base station LCD dis-
plays the docking module number, and the type and
serial number of the detector.
10

Using the Base Station

a
To prevent possible personal injury and/or property
damage, only use the station in a safe area that is free of
hazardous gas.
Ensure that the station is attached to a venting system or
used in a well ventilated area.
The base station pushbuttons are not labelled. The base station
is operated by pressing the C pushbutton that is located
directly below the option that displays on the LCD.

Activating the Station

1. To activate the station, press and hold C (the left-
most button) until the following screen displays.
The normal operation screen then displays.
Warning