Configuring A Static Ip Address On The Spa9000 (If Prompted) - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment
Configuring the SPA9000
NOTE
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
This message may occur for the following reasons:
•
The network cable is disconnected from the SPA9000 INTERNET port or the
switch port. Check the cables to ensure that the SPA9000 is properly
connected to the switch.
•
The Wizard is running on a computer that is not on the same local network as
the SPA9000. Check the IP address of the administration computer.
•
WAN access is not enabled on the SPA9000. This issue should not occur with a
new device, where WAN access is enabled by default, but may occur on a
device that was configured previously. Follow the instructions on the screen to
ensure that WAN access is enabled and to learn the IP address of the
SPA9000.
•
After correcting any errors that you find, click Back to return to the previous
screen. Then click Next, and the Wizard attempts to discover the SPA9000.
If the Manually Input SPA9000 IP Address screen appears after you complete these
troubleshooting steps, enter the IP address, and then click Next to continue.
Configuring a Static IP Address on the SPA9000 (If
Prompted)
The Wizard tests the SPA9000 device to verify that it is configured with a static IP
address in order to ensure professional-grade uptime. The SPA9000 device would
not be able to provide PBX functions to devices that cannot locate it if its IP
address was changed by a DHCP server.
Complete this procedure if the Wizard displays the following message: D
configured to use DHCP
.
4
evice is
59