Localizing The Spa9000 - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment

Localizing the SPA9000

Localizing the SPA9000
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
The Localization page appears after you click the Next button to display the
Configure SPA9000 Hunt Groups page.
You can localize the SPA9000 by selecting your country, time zone, preferred date
and time formats, and NTP server. The SPA9000 will update the dial plan and the
Auto Attendant prompts based on the selected country.
•
Phones get the time settings from the SPA9000. The SPA9000 may get its time
settings from multiple sources: its internal clock, the specified NTP server, or
the service providers (including SPA400 devices).
•
When the SPA9000 is offline (not subscribed to a service provider, with no
specified NTP server or no connection to a specified NTP server), the internal
clock is used.
•
When there is an NTP server and one or more service providers, the source
that provided the time most recently is used as the time source. Usually, this
source is the service provider because the time is updated whenever the
SPA9000 re-registers with the service provider (order of minutes). The NTP
server time update occurs less frequently (order of hours).
•
When there is a SPA400, the time source is the designated NTP server. The
NTP server set on the localization page applies to both SPA9000 and SPA400.
4
76