Connecting the Equipment
Configuring Client Stations
STEP 1
STEP 2
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
Configuring a Client Station
The Configure Client Station - Select an IP Phone page appears after you click the
Next button on the Configure the SPA9xx IP Phone page. You can assign an
extension to the telephone. On the SPA942 and SPA962, you also can configure
the line keys for shared line appearances (SLA), Busy Lamp Field (BLF), Speed Dial
(SD), and Call Pickup (CP).
Click Refresh List to cause the Wizard to search for recently added phones.
From the Current Phone list, choose the MAC address of the first phone that you
want to configure, and then click Next to cause the Wizard to connect to the phone.
•
As you go through these steps, refer to your list of phones, extensions, and
MAC addresses in order to assign each phone to its associated owner.
•
After you choose a phone from the list and click the Next button, the Wizard
verifies that the selected device passes the minimum firmware version
requirement. If outdated firmware is detected, a message appears. You must
upgrade the firmware if this message appears. See
Firmware (If Prompted)," on page
"Upgrading the Phone
93.
4
85