Connecting the Equipment
Connecting and Configuring the Equipment (New Installation)
STEP 4
STEP 1
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
Proceed according to the prompt or menu that appears:
•
If a Click OK to Upgrade message appears, click OK to upgrade the firmware.
•
Device is configured to use DHCP
If the
address. See
"Configuring a Static IP Address on the SPA400 (If Prompted),"
on page
55.
•
If the Main Menu appears, continue with the configuration. See
SPA9000," on page
Configuring a Static IP Address on the SPA400 (If Prompted)
The Wizard tests each SPA400 device to verify that it is configured with a static IP
address in order to ensure professional-grade uptime. The SPA400 devices would
not be available for PSTN calls or voice mail services if its IP address was
changed by a DHCP server.
Complete this procedure if the Wizard displays the following message:
configured to use DHCP
Click OK to display the Network Settings page.
message appears, configure a static IP
57.
.
4
"Configuring the
Device is
55