Manually Inputting The Spa9000'S Ip Address (If Prompted) - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment
Configuring the SPA9000
STEP 4
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
Proceed according to the prompts that appear:
•
If the Manually Input SPA9000 IP Address page appears, troubleshoot the
problem. See "Manually Inputting the SPA9000's IP Address (If Prompted)," on
page 58.
•
Device is configured to use DHCP
If the
address. See "Configuring a Static IP Address on the SPA9000 (If Prompted),"
on page 59.
•
Firmware upgrade required!
If the
firmware. See "Upgrading SPA9000 Firmware (If Prompted)," on page
•
If the Wizard displays the Configure SPA9000 Voice Services page, continue to
the next step in the configuration process. See
Service Lines," on page

Manually Inputting the SPA9000's IP Address (If Prompted)

If the Wizard cannot detect a SPA9000, the following screen appears:
message appears, set a static IP
message appears, upgrade the SPA9000
63.
"Configuring SPA9000 Voice
4
62.
58