Configuring The Spa9000 - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment

Configuring the SPA9000

Configuring the SPA9000
STEP 1
STEP 2
STEP 3
SPA9000 Voice System Installation and Configuration Guide for Setup Wizard
When the Main Menu appears, you are ready to configure the SPA9000. You will
set a static IP address and upgrade firmware if needed.
On the Main Menu, select Configure SPA9000.
Click Next to cause the Wizard to discover all connected SPA9000 devices
connected to the network.
Only one SPA9000 is supported. Any unused SPA9000 devices should be
NOTE
disconnected from the LAN.
Wait as the Wizard displays progress messages on the PC screen.
If the Wizard is unable to detect the SPA9000, either the SPA9000 INTERNET
NOTE
port is not connected to the LAN switch, or you have some other LAN
networking problem that needs to be resolved before you can continue. See
"Manually Inputting the SPA9000's IP Address (If Prompted)," on page
4
58.
57