Configuring The Spa400 Network Connection - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment
Installing the SPA400
STEP 1
STEP 2
STEP 3
SPA9000 Voice System Installation and Configuration Guide for Web UI

Configuring the SPA400 Network Connection

You need to configure a fixed IP address for your SPA400.
Start Internet Explorer, and enter the IP address of the SPA400.
•
By default, the SPA400 is configured to obtain an IP Address via DHCP. You can
check the obtained IP address on the router DHCP server's client list.
•
If your SPA400 has been used before or it is not reachable, factory reset the
unit by pressing the Reset button for 10 seconds.
When the password prompt appears, enter the default user name, Admin, with no
password. Then click OK.
The user name must be entered exactly as shown: Admin. For information
NOTE
about managing system access, refer to the Cisco
Administration Guide
Click Setup tab > Basic Setup.
.
4
SPA9000 Voice System
61