Enabling Eap-Tls Authentication - Cisco AIR-PCI340 Installation And Configuration Manual

Configuring the Client Adapter

Enabling EAP-TLS Authentication

Follow the steps below to prepare the client adapter to use EAP-TLS authentication, provided you have
completed the initial configuration.
Click the Authentication tab on the Wireless Network Properties screen. The following screen appears
Step 1
(see
Figure E-3
Step 2 Check the Enable IEEE 802.1x authentication for this network check box if you did not enable WPA
or WPA-PSK on the Association screen.
Step 3 For EAP type, select Smart Card or other Certificate.
Step 4 Click Properties. The Smart Card or Other Certificate Properties screen appears (see
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
E-10
Figure E-3).
Wireless Network Properties Screen (Authentication Tab)
Appendix E Configuring the Client Adapter through the Windows XP Operating System
Figure E-4).
OL-1394-07