Cisco AIR-PCI340 Installation And Configuration Manual page 50

Installing or Upgrading the Client Adapter Software
Table 3-2
Component or Parameter
Firmware
Disable Firmware
Checking
Drivers
Aironet Client Utility
Installation Path
Program Folder
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
3-16
Software Components and Their Parameters
Description
Installs the firmware version included in the Install Wizard file.
Default: Checked
The Disable Firmware Checking parameter affects the firmware that
is bundled with the driver, not the firmware that is included in the
Install Wizard. This parameter controls whether the driver (whenever
it loads) installs the firmware with which it is bundled.
Note
Options: Yes or No
Default: Yes
Disable Firmware Checking Description
Yes
No
Note
Note
Installs the driver version included in the Install Wizard file.
Default: Checked
Installs the ACU version included in the Install Wizard file.
Default: Checked
Determines the path where the ACU software will be installed. You
can change the default by entering a new path.
Default: C:\Program Files\Cisco Systems\Aironet Client Utility
Determines the program folder where the ACU software will be
installed. You can change the default by entering a new folder name.
Default: Cisco Systems
The driver loads each time you insert a client adapter or
reboot your computer.
Prevents the driver from installing the
firmware with which it is bundled,
enabling the client adapter to retain its
current firmware version.
Causes the driver to install the firmware
with which it is bundled if that firmware is
newer than the firmware that is currently
installed in the client adapter.
This parameter is functionally equivalent to the
Automatically Load New Firmware When NDIS Driver Is
Updated parameter on the ACU Preferences screen. The
parameter that is set last is the one that governs how the driver
behaves. Refer to the "Preventing the Driver from Upgrading
the Firmware" section on page 9-10
information.
The Disable Firmware Checking parameter is available in
Install Wizard version 1.1 or greater.
Chapter 3 Installing the Client Adapter
for additional
OL-1394-07