Enabling Peap Authentication - Cisco AIR-PCI340 Installation And Configuration Manual

Appendix E Configuring the Client Adapter through the Windows XP Operating System

Enabling PEAP Authentication

Follow the steps below to prepare the client adapter to use PEAP authentication, provided you have
completed the initial configuration.
Click the Authentication tab on the Wireless Network Properties screen. The following screen appears
Step 1
(see
Figure E-5
Check the Enable IEEE 802.1x authentication for this network check box if you did not enable WPA
Step 2
or WPA-PSK on the Association screen.
Step 3 For EAP type, select PEAP. Click Properties. The PEAP Properties screen appears (see
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
Figure E-5).
Wireless Network Properties Screen (Authentication Tab)
Configuring the Client Adapter
Figure E-6).
E-13