Cisco AIR-PCI340 Installation And Configuration Manual page 163

Chapter 7 Performing Diagnostics
Figure 7-6
Step 2 In the IP Address of Access Point field, enter the IP address of the access point or other wireless device
with which you want to test the RF link.
Step 3 You can set the link test to run until it has attempted to send a specific number of packets or to run until
you stop it. Follow one of the steps below to determine how long the link test will run:
• Select the number of packets that the link test should attempt to send. You can type a number in the
Number of Packets field or use the slider to select this value. (The Number of Packets parameter is
ignored if the Continuous Linktest check box is checked.)
Range: 1 to 1000
Default: 4
• Check the Continuous Linktest check box to allow the link test to run continuously.
Default: Unchecked
Step 4 Select the size of the data packet that is to be sent to the access point. You can type a number in the Packet
Size field or use the slider to select this value.
Range: 64 to 2048
Default: 100
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
Linktest Screen
Running an RF Link Test
7-19