Cisco AIR-PCI340 Installation And Configuration Manual page 55

Chapter 3 Installing the Client Adapter
Figure 3-7
On the IP Address tab, find and select the client adapter that you are installing under Adapter.
Step 23
Perform one of the following:
Step 24
If your computer is connected to a DHCP server, select Obtain an IP address from a DHCP server.
•
When asked if you want to enable DHCP, click Yes and OK.
If your computer is not connected to a DHCP server and you plan to use TCP/IP, select Specify an
•
IP address and enter the IP address, subnet mask, and default gateway address of your computer
(which can be obtained from your system administrator). Click OK.
The installation process begins, and you are notified as each component is installed.
Windows NT must be rebooted in order for your changes to take effect. Click Yes when a message
Step 25
appears asking if you wish to reboot now.
To prevent unpredictable results, Cisco recommends that you click Yes to reboot your computer now.
Caution
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
Microsoft TCP/IP Properties Screen
Installing or Upgrading the Client Adapter Software
3-21