Cisco AIR-PCI340 Installation And Configuration Manual page 44

Installing or Upgrading the Client Adapter Software
Table 3-1
Component or Parameter
PEAP
When you are finished making selections, click Next.
e.
The installation process begins, and you are notified as each component is installed. Perform one of the
Step 17
following:
If a message appears asking if you wish to reboot now, click Yes.
•
Note
If a message appears indicating that the system is about to reboot, click OK and allow your computer
•
to restart.
If the following message appears, click OK and then reboot your computer: "The installation will
•
complete and applications will be installed when a wireless LAN client adapter is inserted. If an
adapter is already inserted, remove and reinsert the adapter or reboot the machine."
The Found New Hardware screen appears. Depending on your computer's operating system, you
may have to click Next. The driver and other software components are installed. Then an ACM icon
appears in the Windows system tray (unless you changed the default value during installation).
Perform one of the following:
–
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
3-10
Software Components and Their Parameters (continued)
Description
Installs the PEAP supplicant version included in the Install Wizard
file. Installing the PEAP supplicant enables the client to support
PEAP authentication. If this option is not selected now and you later
want to use PEAP, you must run this installation program again and
select this option.
Default: Unchecked
Note
Note
Note
To ensure that your client adapter software is installed properly, Cisco recommends that you
click Yes to reboot your computer now.
If a message appears asking if you wish to reboot now, click Yes.
To ensure that your client adapter software is installed properly, Cisco recommends that
Note
you click Yes to reboot your computer now.
Refer to Chapter 5 for information on enabling PEAP.
To enable Cisco PEAP authentication, your computer must
run Windows 2000 with the Microsoft 802.1X supplicant
installed or Windows XP.
Windows XP Service Pack 1 and the Microsoft 802.1X
supplicant for Windows 2000 include Microsoft's PEAP
supplicant, which supports a Windows username and
password only and does not interoperate with Cisco's PEAP
supplicant. To use Cisco's PEAP supplicant, install the Install
Wizard file after Windows XP Service Pack 1 or the Microsoft
802.1X supplicant for Windows 2000. Otherwise, Cisco's
PEAP supplicant is overwritten by Microsoft's PEAP
supplicant.
Chapter 3 Installing the Client Adapter
OL-1394-07