Acu Procedures; Opening Acu - Cisco AIR-PCI340 Installation And Configuration Manual

Client Adapter Software Procedures
Note
Click OK.
Step 4

ACU Procedures

This section provides instructions for the following procedures:
•
•
•
•
•
•

Opening ACU

To open ACU, perform one of the following:
•
•
•
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
9-12
The Automatically Load New Firmware When NDIS Driver Is Updated parameter is dependent
on the radio type (and the Cardbus slot for PC-Cardbus cards). Therefore, if you insert a client
adapter of a different card type (such as a 340 instead of a 350) or insert the same PC-Cardbus
card into a different slot, whether or not the driver installs the firmware with which it is bundled
depends on how this parameter (or the Disable Firmware Checking parameter) was last set for
that card type or card slot.
Opening ACU, below
Exiting ACU, page 9-13
Modifying ACU installation settings,
Finding the version of ACU,
Adding the ACU icon to or removing it from the desktop,
Accessing online help, page 9-14
Double-click the Aironet Client Utility (ACU) icon on your desktop.
Select Aironet Client Utility (ACU) from the folder in the Windows Start Menu that you chose
during installation [the default location is Start > Program Files > Cisco Systems > Aironet Client
Utility (ACU)].
Double-click My Computer > Control Panel > Aironet Client Utility.
page 9-13
page 9-13
Chapter 9 Routine Procedures
page 9-14
OL-1394-07