Cisco AIR-PCI340 Installation And Configuration Manual page 211

Chapter 10 Troubleshooting
Error Message Restarting the client adapter will cause you to lose your network
connection. Are you sure you want to restart your client adapter?
Explanation
which may cause you to lose your network connection.
Recommended Action
Error Message Unable to Open filename
Explanation
Recommended Action
try to load it again or select a different firmware file and try to load it.
Error Message Wireless Connection Unavailable. (Windows XP only)
Explanation
configure my wireless network settings check box in Windows XP is checked. This message
appears even if the client adapter is associated to an access point.
Recommended Action
box in Windows XP to force Windows to display the correct status.
Error Message You cannot run a link test because your client adapter is not
associated.
Explanation
access point or other wireless device.
Recommended Action
another wireless device.
Error Message You cannot run a link test because your client adapter's radio is
turned off.
Explanation
Recommended Action
drop-down menu in ACU; then run the link test.
Error Message You must enter WEP key 1! (Press the "Static WEP Keys" button to open
the Static WEP Keys dialog box.)
Explanation
entered.
Recommended Action
instructions in the
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
The Restart Card option was selected from the Commands drop-down menu in ACU,
If you want to reinitialize your client adapter, click Yes. Otherwise, click No.
The selected firmware file cannot be found.
Re-copy the firmware file to a floppy disk or to your computer's hard drive and
ACU was used to configure the client adapter on Windows XP, but the Use Windows to
Uncheck the Use Windows to configure my wireless network settings check
An attempt was made to run a link test while the client adapter was not associated to an
Run the link test after the client adapter is associated to an access point or
An attempt was made to run a link test while the client adapter's radio was off.
Turn on the client adapter's radio by selecting Radio On from the Commands
Static WEP was selected on the Network Security screen, but a WEP key was not
Click Static WEP Keys on the Network Security screen. Then follow the
"Entering a New Static WEP Key" section on page 5-32
Error Messages
to enter a static WEP key.
10-17