After A Reboot Or Logon - Cisco AIR-PCI340 Installation And Configuration Manual

Chapter 6 Using EAP Authentication

After a Reboot or Logon

After your computer reboots or you log on, follow the steps below to LEAP authenticate.
When the LEAP login screen appears (see
Step 1
click OK. The domain name is optional.
Figure 6-5
Note
Note
The LEAP Authentication Status screen appears.
Step 2 If your client adapter authenticates, the screen shows that each stage was successful and then disappears.
ACM now shows Authenticated, and the Server Based Authentication field on the ACU Status screen
shows LEAP Authenticated.
If the authentication attempt fails, an error message appears after the LEAP timeout period has expired.
Refer to the
take.
When the network login screen appears (see
Step 3
and password and click OK.
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
LEAP Login Screen
The LEAP login screen shown above appears on computers running Windows NT, 2000, or XP.
The LEAP login screen looks slightly different on computers running other Windows operating
systems.
The LEAP login screen should appear before the Windows login screen on computers running
Windows 98, 98 SE, or Me. If the Windows screen appears first, follow the instructions in the
"LEAP Login Screen Does Not Appear Before Windows Login Screen (Windows 98, 98 SE, and
Me Only)" section on page
login screen appears after the Windows login screen.
"LEAP Authentication Error Messages" section on page 10-20
Using LEAP with an Automatically Prompted Login
Figure 6-5), enter your LEAP username and password and
10-13. On computers running Windows NT, 2000, or XP, the LEAP
Figure 6-6 and Figure
for the necessary action to
6-7), enter your network username
6-7