Enabling Eap-Tls - Cisco AIR-PCM341 Installation And Configuration Manual

Chapter 5 Configuring the Client Adapter
Step 3 Tap OK to save your changes.
Step 4 Select Start > Programs > Cisco > AuthMgr. The Authentication screen appears (see
Figure 5-7
Perform one of the following, depending on the authentication type you want to use:
Step 5
•
•

Enabling EAP-TLS

Follow the steps below to enable EAP-TLS for this profile.
For EAP Type, select TLS.
Step 1
If your Windows CE device has more than one user certificate, tap the Properties button. On the Select
Step 2
Certificate screen, select the user certificate that you want to use and tap OK.
The configuration is complete. Tap the Connect button on the Authentication screen to start the EAP
Step 3
authentication process.
Note
Refer to the
Step 4
OL-1375-03
Authentication Screen
If you are planning to use EAP-TLS, go to the
If you are planning to use PEAP, go to the
Any time you make a change to the active profile in ACU or the Authentication Manager, you
must tap the Connect button on the Authentication screen to start the authentication process.
"Using EAP-TLS" section on page 6-4
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
"Enabling EAP-TLS"
"Enabling PEAP" section on page
for instructions on authenticating using EAP-TLS.
Using Host-Based EAP
Figure 5-7).
section below.
5-22.
5-21