Enabling Eap-Tls Authentication - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Configuring the Client Adapter
Perform one of the following:
Step 14
•
•
•

Enabling EAP-TLS Authentication

Follow these steps to prepare the client adapter to use EAP-TLS authentication, provided you have
completed the initial configuration.
Check the Enable network access using IEEE 802.1X check box.
Step 1
Select TLS in the EAP type drop-down box.
Step 2
Step 3 If your Windows CE .NET device has more than one user certificate, tap the Properties button. On the
Select Certificate screen, select the user certificate that you want to use and tap OK.
Tap OK to save your settings. The configuration is complete. The client adapter automatically attempts
Step 4
to associate to the network(s) in the order in which they are listed. When the client adapter is associated
to an access point, the word Connected appears to the right of the network name in the list of wireless
networks.
Refer to the
Step 5
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
E-8
Enter the WEP key in the Network key field. In order to communicate, the client adapter must
c.
use the same WEP key as the access point or other clients.
In the Key index field, enter the number of the WEP key you are creating (1, 2, 3, or 4).
d.
The WEP key must be assigned to the same number on both the client adapter and the
Note
access point (in an infrastructure network) or other clients (in an ad hoc network).
If you are not planning to use EAP authentication, tap OK to save your settings and to add this SSID
to the list of wireless networks (see
associate to the network(s) in the order in which they are listed. When the client adapter is associated
to an access point, the word Connected appears to the right of the network name in the list of wireless
networks.
If you are planning to use EAP-TLS authentication, follow the instructions in the
EAP-TLS Authentication"
If you are planning to use PEAP authentication, follow the instructions in the
Authentication" section on page
"Using EAP-TLS" section on page 6-5
Appendix E Configuring the Client Adapter through Windows CE .NET
Figure E-1). The client adapter automatically attempts to
section below.
E-9.
for instructions on authenticating using EAP-TLS.
"Enabling
"Enabling PEAP
OL-1375-04