Synchronizing Security Features - Cisco AIR-PCI340 Installation And Configuration Manual

Chapter 5 Configuring the Client Adapter

Synchronizing Security Features

In order to use any of the security features discussed in this section, both your client adapter and the
access point to which it will associate must be set appropriately.
point settings required for each security feature. This chapter provides specific instructions for enabling
the security features on your client adapter. Refer to the documentation for your access point for
instructions on enabling any of these features on the access point.
Table 5-6
Security Feature
Static WEP with open
authentication
Static WEP with shared key
authentication
LEAP authentication
LEAP authentication with
WPA
EAP-TLS authentication
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
Client and Access Point Security Settings
Client Setting
Disable Network Authentication,
enable Static WEP and Open
Authentication and create a WEP
key
Disable Network Authentication,
enable Static WEP and Shared Key
Authentication and create a WEP
key
Enable LEAP
Enable LEAP and Wi-Fi Protected
Access (WPA)
Note
If using ACU to Enable Host Based EAP (802.1x)
configure card and Dynamic WEP in ACU and
select Enable network access
control using IEEE 802.1X (or
Enable IEEE 802.1x authentication
for this network) and Certificates
(or Smart Card or other Certificate)
as the EAP Type in Windows
If using Windows XP Select Enable network access
to configure card control using IEEE 802.1X and
Smart Card or other Certificate as
the EAP Type
Table 5-6
To allow the client to
associate to both WPA and
non-WPA access points,
enable Allow Association
to both WPA and non-WPA
authenticators.
Setting Network Security Parameters
indicates the client and access
Access Point Setting
Set up and enable WEP and enable
Open Authentication for the SSID
Set up and enable WEP and enable
Shared Key Authentication for the
SSID
Set up and enable WEP and enable
Network-EAP for the SSID
Select a cipher suite that includes
TKIP, set up and enable WEP, and
enable Network-EAP and WPA for
the SSID
To allow both WPA and
Note
non-WPA clients to use the
SSID, enable optional
WPA.
Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
5-29