Cisco AIR-PCI340 Installation And Configuration Manual page 152

Viewing the Current Status of Your Client Adapter
Table 7-3
Status
Authentication Type
Broadcast Encryption Type
WPA Authentication
Fast Roaming
Antenna Selection
Channel Set
Client Name
MAC Address
IP Address
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
7-8
Client Adapter Status (continued)
Description
Indicates whether the client adapter must share the same WEP keys as
the access point in order to communicate or can communicate with the
access point regardless of its WEP settings.
Value:
Note
Indicates the type of encryption that is being used for broadcast and
multicast packets.
Value:
Note
Indicates whether WPA is enabled on the client adapter and the access
point to which it is associated.
Value:
Note
Indicates whether fast roaming is enabled on the client adapter.
Value:
Note
The antenna mode that your client adapter is currently using.
Value:
Note
Note
The regulatory domain for which your client adapter is currently
configured, such as Americas. (For the Japan channel set, the Call ID is
also displayed.) This value is not user selectable.
Note
The name your client adapter uses when it associates to an access point.
Note
The MAC address assigned to your client adapter at the factory.
The IP address of your client adapter.
Open or Shared Key
Refer to the "Setting Network Security Parameters" section on
page 5-21 for information on setting the authentication type.
None, WEP, TKIP, or CKIP
Refer to the "Overview of Security Features" section on
page 5-22 for details on these encryption types.
None or WPA
Refer to the "Wi-Fi Protected Access (WPA)" section on
page 5-26 for more information on WPA.
None or CCKM
Refer to the "Fast Roaming (CCKM)" section on page 5-26
more information on fast roaming.
Diversity, Primary Only, Secondary Only
(Primary Only is the only option available for PCI client
adapters)
This setting appears only for 2.4-GHz client adapters.
The Primary Only and Secondary Only values were formerly
named Right Only and Left Only, respectively. Refer to the
Antenna Mode (Receive) and Antenna Mode (Transmit)
parameters in Table 5-4 and
setting the antenna mode.
Refer to Appendix D for a list of channel identifiers, channel
center frequencies, and regulatory domains for each channel.
Refer to the Client Name parameter in
information on setting the client name.
Chapter 7 Performing Diagnostics
Table 5-5 for information on
Table 5-2 for
OL-1394-07
for