Cisco AIR-PCI340 Installation And Configuration Manual page 165

Chapter 7 Performing Diagnostics
Table 7-5
Table 7-5
Linktest Statistic
Packets Received OK
Packets Transmitted OK
Status
Current Link Speed
Associated Access Point Name
Associated Access Point MAC
Address
Current Signal Strength
Current Signal Quality
(2.4-GHz client adapters)
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-07
interprets the statistics that are displayed on the Linktest screen while the link test is running.
Linktest Statistics
Description
The number of packets of the specified size that have been
received successfully.
The number of packets of the specified size that have been
transmitted successfully.
The operational mode of your client adapter.
Value: Error, Configured, Associated, Not Associated, or
Ad Hoc Mode
The rate at which your client adapter is currently transmitting
data packets.
Value: 1, 2, 5.5, or 11 Mbps (2.4-GHz client adapters);
6, 9, 12, 18, 24, 36, 48, or 54 Mbps (5-GHz client
adapters)
The name of the access point to which your client adapter is
associated. It is shown only if the client adapter is in
infrastructure mode, the access point was configured with a name,
and Aironet Extensions are enabled (on access points running
Cisco IOS Release 12.2(4)JA or greater).
The MAC address of the access point to which your client adapter
is associated. It is shown only if the client adapter is in
infrastructure mode.
Note This field displays the MAC address of the access point's
Ethernet port (for access points that do not run Cisco IOS)
or the MAC address of the access point's radio (for access
points that run Cisco IOS). The MAC address of the
Ethernet port on access points that run Cisco IOS is
printed on a label on the back of the device.
The signal strength for all received packets. The higher the value
and the more green the bar graph is, the stronger the signal.
Range: 0 to 100% or –95 to –45 dBm
The signal quality for all received packets. The higher the value
and the more green the bar graph is, the clearer the signal.
Range: 0 to 100%
Note This setting appears only for 2.4-GHz client adapters and
only if you selected signal strength to be displayed as a
percentage. See the Signal Strength Display Units
parameter in Table 7-2
Running an RF Link Test
for information.
7-21