Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 83

Chapter 1 Product Overview
Table 1-21 Catalyst 6513 Switch Features (continued)
Feature
Modules
Backplane bandwidth
Clock and VTT module
OL-5781-08
Description
Supports up to 12 Catalyst 6500 series modules.
•
When using a Supervisor Engine 2 the WS-C6500-SFM and
•
WS-X6500-SFM2 Switch Fabric Modules must be installed in slot 7 or
slot 8.
Mixing WS-C6500-SFM and WS-X6500-SFM2 Switch Fabric
Note
Modules is not allowed in the Catalyst 6513 chassis.
Slots 1–8 support a single fabric channel; slots 9–13 support dual fabric
•
channels.
The following modules are supported only in chassis slots 9–13 and do
•
not power up when they are installed in the other chassis slots:
WS-X6748-SFP
–
– WS-X6748-GE-TX
WS-X6704-10GE
–
WS-X6708-10GE
–
WS-X6716-10GE
–
WS-X6816-GBIC
–
WS-SVC-WISM-1-K9
–
The WS-X6724-SFP Ethernet module has a single fabric channel and
Note
is supported in all Catalyst 6513 switch chassis slots.
Check your software release notes for specific information on module
•
support. Some Catalyst 6500 series modules may:
Not be supported
–
Require that you install a Supervisor Engine 720
–
Have chassis slot restrictions
–
Require a specific software release level to operate
–
32 GBps shared bus.
•
256 GBps switch fabric.
•
720 GBps switch fabric.
•
Two replaceable clock modules (WS-C6513-CL=) provide clocking
•
signals to the EOBC channel and the switching bus.
Three replaceable voltage termination (VTT) modules
•
(WS-C6K-VTT=) provide reference voltage for bus signals.
Catalyst 6500 Series Switches Installation Guide
Catalyst 6513 Switch
1-63