Optional Installation Kits; Installing A Catalyst 6509 Or Catalyst 6509-E Switch Chassis; Installation Accessory Kits; L Brackets On The Catalyst 6509 And Catalyst 6509-E Switches - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual

Chapter 3 Installing the Switch

Optional Installation Kits

An optional rubber feet installation kit is included in the accessory kit for the Catalyst 6506-E switch
chassis. This kit contains the parts necessary to install four non-slip rubber feet on the bottom of the
chassis allowing the chassis to placed on a shelf or a table. To install the rubber feet, go to
the Rubber Feet Kit" section on page
A center rack-mount kit for 23-inch, telco-style racks is available as an option for both the Catalyst 6506
and the Catalyst 6506-E switch chassis. The kit is not included in the accessory kits, but is available as
a separately orderable item (p/n WS-C6597=). Installation instructions are included with the kit.

Installing a Catalyst 6509 or Catalyst 6509-E Switch Chassis

This section provides procedures for installing either a Catalyst 6509 or a Catalyst 6509-E switch
chassis in a rack assembly and installing the optional cable guide assemblies.

Installation Accessory Kits

The Catalyst 6509 and Catalyst 6509-E switch chassis are designed to be installed in a standard 19-inch
rack, either open or enclosed. Both chassis are normally shipped with the 19-inch rack-mount L brackets
factory installed on the left-front and right-front of the chassis. Included with the accessory kit are 10-32
x 0.75-inch and 12-24 x 0.75-inch screws that are used to secure the chassis in the rack enclosure.
Note Depending on the manufacturer, the rack posts might be prethreaded to accept either 10-32 or 12-24
screws. If the rack posts are not prethreaded, you must install 10-32 or 12-24 clip nuts or cage nuts to
secure the rack-mount screws. The clip nuts or the cage nuts are not included as part of the accessory kit
and must be obtained on your own.
Depending on the chassis model, the accessory kit might also contain the following chassis installation
kits:
•
•
Also included in the accessory kit:
•
•

L Brackets on the Catalyst 6509 and Catalyst 6509-E Switches

The Catalyst 6509 and Catalyst 6509-E switch chassis are shipped with two L brackets installed on the
front sides of the chassis. The L brackets are secured to the chassis with ten M3 Phillips-head
countersunk screws (five M3 screws on each side) as shown in
OL-5781-08
Rack-mount shelf kit (Catalyst 6509 and Catalyst 6509-E). The rack-mount shelf kit is used to
support the weight of the chassis while you secure the chassis L brackets to the rack enclosure.
Rubber feet mount kit (Catalyst 6509-E accessory kit only). This kit can be installed when you want
to install the Catalyst 6509-E chassis as a freestanding unit on a shelf or a table.
Cable guides— Two cable guides can be installed on the front of the chassis using the same sets of
screws that secure the chassis rack-mount brackets to the rack posts.
Power supply blank panel—The power supply blank panel must be installed on an unused power
supply bay to maintain chassis airflow and EMI shielding.

Installing a Catalyst 6509 or Catalyst 6509-E Switch Chassis

3-50.
Figure
Catalyst 6500 Series Switches Installation Guide
"Installing
3-9.
3-21