Rack-Mounting The Chassis - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual

Installing a Catalyst 6509-V-E Switch Chassis

Rack-Mounting the Chassis

Tip We recommend that you have a third person to assist in this procedure.
For easier installation, the chassis should be empty when you install it in the rack.
Caution
Two people are required to lift the chassis. To prevent injury, keep your back straight and lift with your
Warning
legs, not your back. Statement 164
To install the switch chassis in the equipment rack, follow these steps:
With a person standing at each side of the chassis, grasp the chassis handle with one hand, and use the
Step 1
other hand near the back of the chassis for balance. Slowly lift the chassis in unison. Avoid sudden twists
or moves to prevent injury.
Step 2 Position the chassis in the rack as follows:
a.
b.
Align the mounting holes in the L bracket with the mounting holes in the equipment rack.
Step 3
Step 4 Install the eight or ten (four or five per side) 12-24 x 3/4-inch or 10-32 x 3/4-inch screws through the
holes in the L bracket mounting holes, and into the threaded holes in the equipment rack posts. (See
Figure
Use a tape measure and level to verify that the chassis is installed straight and level.
Step 5
Catalyst 6500 Series Switches Installation Guide
3-38
If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between
the mounting posts, resting the chassis on the shelf brackets, and then carefully slide the chassis into
the rack.
If the rear of the chassis is at the front of the rack, insert the front of the chassis between the
mounting posts, resting the chassis on the shelf brackets, and then carefully slide the chassis into the
rack.
3-20.)
Chapter 3 Installing the Switch
OL-5781-08