Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 182

Installation guide
Hide thumbs Also See for 6503 - Catalyst Firewall Security Sys:
Table of Contents

Advertisement

Attaching the Interface Cables
The accessory kit that shipped with your Catalyst 6500 series switch contains the necessary cable and
Note
adapters to connect a terminal or modem to the console port.
To connect a terminal to the console port using the cable and adapters provided, follow these steps:
Place the console port mode switch in the in position (factory default).
Step 1
Connect to the port using the RJ-45-to-RJ-45 cable and RJ-45-to-DB-25 DTE adapter or RJ-45-to-DB-9
Step 2
DTE adapter (labeled "Terminal").
Position the cable in the cable guide (if installed). Make sure there are no sharp bends in the cable.
Step 3
Check the terminal documentation to determine the baud rate. The baud rate of the terminal must match
Step 4
the default baud rate (9600 baud) of the console port. Set up the terminal as follows:
9600 baud
8 data bits
No parity
2 stop bits
To connect a terminal using a Catalyst 5000 family Supervisor Engine III console cable, follow these
steps:
Place the console port mode switch in the out position.
Step 1
Connect to the port using the Supervisor Engine III cable and the appropriate adapter for the terminal
Step 2
connection.
Position the cable in the cable guide (if installed). Make sure there are no sharp bends in the cable.
Step 3
Check the terminal documentation to determine the baud rate. The baud rate of the terminal must match
Step 4
the default baud rate (9600 baud) of the console port. Set up the terminal as follows:
9600 baud
8 data bits
No parity
2 stop bits
To connect a modem to the console port, follow these steps:
Place the console port mode switch in the in position.
Step 1
Connect to the port using the RJ-45-to-RJ-45 rollover cable and the RJ-45-to-DB-25 DCE adapter
Step 2
(labeled "Modem").
Position the cable in the cable guide (if installed). Make sure there are no sharp bends in the cable.
Step 3
Catalyst 6500 Series Switches Installation Guide
3-62
Chapter 3
Installing the Switch
OL-5781-08

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6500 series

Table of Contents