Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 249

Chapter 4 Removal and Replacement Procedures
Figure 4-29
Ø .267
2 holes
All measurements in inches
Use both hands to install and remove the power supplies. Each DC-input power supply weighs 32 pounds
Caution
(14.5 kg).
Grasp the power supply handle with one hand, and place your other hand underneath the power supply.
Step 5
Slide the power supply into the power supply bay. Make sure that the power supply is fully seated in the
bay. (See
Figure 4-30
0
Tighten the power supply captive installation screw. (See
Step 6
Remove the two screws that secure the outer terminal block cover. Lift the cover up to detach the cover
Step 7
tabs from the slots in the power supply. Set the cover and the screws aside.
OL-5781-08
DC Power Cable Lug
2.25
.25 .63 .37
Figure 4-30.)
Handling a 4000 W DC-Input Power Supply
+ VE-1
+ VE-3
- VE-1
- VE-3
+ VE-2
VE-2 -
I
INPU T OK
FAN OUTP UT
1
2
3 OK FAIL
Removing and Installing the DC-Input Power Supplies
Crimp area
Figure
Catalyst 6500 Series Switches Installation Guide
4-26.)
4-43