Appendix; Chassis And Module Power And Heat Values - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual

Chassis and Module Power and Heat Values

This appendix provides the power and heat numbers for the Catalyst 6500 series chassis and modules.
The following power requirements and heat dissipation tables are provided:
Chassis and fan
•
IP
•
Supervisor
•
• Policy Feature Cards
Distributed Forwarding Cards
•
• Switch fabric
10-Gigabit Ethernet
•
• Gigabit Ethernet
10/100/1000 Ethernet
•
Fast Ethernet switching
•
10/100 Ethernet switching
•
10BASE Ethernet switching
•
FlexWAN and Enhanced FlexWAN
•
Service
•
Miscellaneous
•
Unless otherwise noted, the information in the following tables is measured under fully loaded
conditions (transceivers installed). Typical numbers are approximately 20 percent below the numbers
listed in these tables.
Module power is the output from the power supply (internal to the system). The AC-input power is the
Note
input from the outlet to the power supply. The percentage difference between the two values is the
efficiency of the power supply.
OL-5781-08
trays—Table D-1
phones—Table D-2
engines—Table D-3
(PFCs)—Table D-4
modules—Table D-6
modules—Table D-7
modules—Table D-8
modules—Table D-9
modules—Table D-10
modules—Table D-11
modules—Table D-12
modules—Table D-14
modules—Table D-15
A P P E N D I X
(DFCs)—Table D-5
modules—Table D-13
Catalyst 6500 Series Switches Installation Guide
D
D-1