Connecting The Supervisor Engine Uplink Ports - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Chapter 3
Installing the Switch
Connecting the Supervisor Engine Uplink Ports
This section describes how to connect to the supervisor engine uplink ports. Refer to
information on which uplink ports each type of supervisor engine has.
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments. Statement 1051
Class 1 laser product. Statement 1008
Warning
In a redundant configuration with two supervisor engines, the uplink ports on the redundant (standby)
Note
supervisor engine are active and can be used for normal traffic like any other ports in the chassis.
Table 3-5
Installing Supervisor Engine Uplink Ports
Supervisor Engine
Supervisor Engine 2
Supervisor Engine 32
Supervisor Engine 32 PISA
OL-5781-08
Uplink Port
Two uplink ports. Both ports require that GBIC
transceivers be installed.
WS-SUP32-GE-3B—Nine uplink ports. Eight ports
require that 1000BASE-X SFP transceivers be installed.
One port is a 10/100/1000 port with an RJ-45 connector.
WS-SUP32-10GE-3B—Three uplink ports. Two ports
require that 10GBASE XENPAK transceivers be installed.
One port is a 10/100/1000 port with an RJ-45 connector.
WS-S32-GE-PISA—Nine uplink ports. Eight ports require
that 1000BASE-X SFP transceivers be installed. One port
is a 10/100/1000 port with an RJ-45 connector.
WS-S32-10GE-PISA—Three uplink ports. Two ports
require that 10GBASE XENPAK transceivers be installed.
One port is a 10/100/1000 port with an RJ-45 connector.
Attaching the Interface Cables
Procedures
"Installing and Cabling
GBIC Transceiver Uplink
Ports" section on
page 3-64
"Installing and Cabling
Optical SFP Transceiver
Uplink Ports" section on
page 3-66
"Installing and Cabling
Copper SFP Transceiver
Uplink Ports" section on
page 3-68
"Installing and Cabling
10GBASE-X XENPAK
Transceiver Uplink Ports"
section on page 3-70
"Installing and Cabling
Optical SFP Transceiver
Uplink Ports" section on
page 3-66
"Installing and Cabling
Copper SFP Transceiver
Uplink Ports" section on
page 3-68
"Installing and Cabling
10GBASE-X XENPAK
Transceiver Uplink Ports"
section on page 3-70
Catalyst 6500 Series Switches Installation Guide
Table 3-5
for
3-63
Advertisement
Table of Contents
Troubleshooting
