Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 188

Attaching the Interface Cables
Installing and Cabling Copper SFP Transceiver Uplink Ports
The copper SFP transceiver, see
transceiver in the module socket. An RJ-45 connector provides the transceiver's interface point to the
network.
Figure 3-37
1
2
Caution To comply with GR-1089 intrabuilding lightning immunity requirements, you must use grounded,
shielded, twisted-pair, Category 5 cabling.
Note When connecting to a 1000BASE-T-compatible server, workstation, or router, use four twisted-pair,
straight-through Category 5 cabling for the SFP transceiver port. When connecting to a
1000BASE-T-compatible switch or repeater, use four twisted-pair, crossover Category 5 cabling.
Catalyst 6500 Series Switches Installation Guide
3-68
SFP Transceiver (Copper)
1
2
3
RJ-45
Bale-clasp latching mechanism shown in the
closed (locked) position
Figure 3-37, has a bale-clasp locking mechanism that secures the
3 Bale-clasp latching mechanism shown in the
open (unlocked) position
Chapter 3 Installing the Switch
OL-5781-08