Cli: Configuring An Inter-Area Router - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
The first diagram shows a network segment with an inter-area router connecting areas 0.0.0.2 and 0.0.0.3.
The example script shows the commands used to configure a 7000 Series Managed Switch as the inter-area
router in the diagram by enabling OSPF on port 1/0/2 in area 0.0.0.2 and port 1/0/3 in area 0.0.0.3.
Port 1/0/2
192.150.2.1
Border
Router
Area 2
Figure 9-1

CLI: Configuring an Inter-Area Router

Step 1: Enable Routing for the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit
Step 2: Assign IP addresses for ports.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit
9-2
Layer 3 Switch acting as
an inter-area router
Port 1/0/3
192.150.3.1
Border
Router
v1.0, November 2008
Area 3
OSPF