Table of Contents
Advertisement
b. Under Configure Routes, make the following selection and enter the following information:
•
Select Static from the Route Type pull-down menu.
•
In the Network Address field, enter 192.168.30.0.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Next Hop IP Address field, enter 192.168.200.1.
c.
Click Add.
Configure Isolated VLANs on a Layer 3 Switch by Using ACLs
Server
10.100.5.252
PC1
192.148.24.2
Figure 12-27
This example shows how to isolate VLANs on a Layer 3 switch by using ACLs. In this example, PC1 is in
VLAN 24, PC2 is in VLAN 48, and server is in VLAN 38. PC1 and PC2 are isolated by an ACL but can
both access the server. The example is shown as CLI commands and as a Web interface procedure.
Access Control Lists (ACLs)
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Port 11/0/38
10.100.5.34
Port 1/0/24
192.148.24.1
v1.0, November 2008
Layer 3 Switch
Port 1/0/48
192.148.48.1
PC2
192.148.48.2
12-25
Advertisement
Table of Contents
