Enable OSPF area 0.0.0.1 on the 1/0/15.
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config)#interface 1/0/15
(Netgear Switch) (Interface 1/0/15)#routing
(Netgear Switch) (Interface 1/0/15)#ip address 192.168.20.2
(Netgear Switch) (Interface 1/0/15)#ip ospf
(Netgear Switch) (Interface 1/0/15)#ip ospf areaid 0.0.0.1
(Netgear Switch) (Interface 1/0/15)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 2
Network
Address
--------------- --------------- ------------
0.0.0.0
0.0.0.0
192.168.20.0
255.255.255.0
Web Interface: Configuring Area 1 as a Stub Area on A2
To use the Web interface to configure OSPF on the switch, proceed as follows:
1.
Enable IP routing on the switch.
a.
From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 9-24
b. Next to the Routing Mode, select the Enable radio button.
c.
Click Apply to save the settings.
OSPF
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Subnet
Mask
Protocol
OSPF Inter
Local
v1.0, November 2008
255.255.255.0
Next Hop
Next Hop
Intf
IP Address
---------
---------------
1/0/15
192.168.20.1
1/0/15
192.168.20.2
9-23