Table of Contents
Advertisement
Subnet
Subnet mask for the LAN. The default value is 255.255.255.0.
gateway
IP address of the default router, if the switch is a node outside the IP range of the LAN.
7.
To enable these changes to be retained during a reset of the switch, type Ctrl-Z to return to the main
prompt, type save config at the main menu prompt, and type y to confirm the changes.
8.
To view the changes and verify in-band information, issue the command: show network.
9.
The switch is configured for in-band connectivity and ready for Web-based management.
Configuring for Out-Of-Band Connectivity
To monitor and configure the switch using out-of-band connectivity, use the console port to connect the
switch to a terminal desktop system running terminal emulation software. The console port connector is a
male DB-9 connector, implemented as a data terminal equipment (DTE) connector.
The following hardware is required to use the console port:
•
VT100-compatible terminal, or a desktop, or a portable system with a serial port running VT100
terminal emulation software.
•
An RS-232 crossover cable with a female DB-9 connector for the console port and the appropriate
connector for the terminal.
Perform the following tasks to connect a terminal to the switch console port using out-of-band connectivity:
1.
Connect an RS-232 crossover cable to the terminal running VT100 terminal emulation software.
2.
Configure the terminal emulation software as follows:
a. Select the appropriate serial port (serial port 1 or serial port 2) to connect to the console.
b. Set the data rate to 9600 baud.
c.
Set the data format to 8 data bits, 1 stop bit, and no parity.
d. Set the flow control to none.
e.
Select the proper mode under Properties.
f.
Select Terminal keys.
Note: When using HyperTerminal with Microsoft Windows 2000, make sure that you
3.
Connect the female connector of the RS-232 crossover cable directly to the switch console port, and
tighten the captive retaining screws.
Getting Started
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
have Windows 2000 Service Pack 2 or later installed. With Windows 2000 Service
Pack 2, the arrow keys function properly in HyperTerminal's VT100 emulation.
Go to
www.microsoft.com
v1.0, November 2008
for more information on Windows 2000 service packs.
1-3
Advertisement
Table of Contents
