Table of Contents
Advertisement
d. In the Address field, enter 10.100.5.17.
e.
Select Enable from the Status pull-down menu.
f.
Click the Add button.
2.
Set the Link Up/Down flag.
a.
From the main menu, select System > SNMP>SNMP V1/V2>Trap Flags. A screen similar to the
following displays.
Figure 21-3
b. Next to the Link Up/Down field, select the Enable radio button.
c.
Click the Apply button.
Configure SNMP V3
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configuring SNMP V3
This example shows how to configure SNMP v3 on the NETGEAR switches.
(Netgear Switch) #config
(Netgear Switch) (Config)#users passwd admin
Enter old password:
Enter new password:12345678
Confirm new password:12345678
Password Changed!
change the password to "12345678"
(Netgear Switch) (Config)#users snmpv3 authentication admin md5
Set the authentication mode to md5
(Netgear Switch) (Config)#users snmpv3 encryption admin des 12345678
Set the encryption mode to des and the key is "12345678"
SNMP
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
21-3
Advertisement
Table of Contents
