NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
3.
In the Client Address field, enter 0.0.0.0.
4.
In the Client IP Mask field, enter 0.0.0.0.
5.
Select the Read/Write from the Access Mode pull-down menu.
6.
Select the Enable from the Status pull-down menu.
7.
Click the Add.
Enable SNMP Trap
The example is shown as CLI commands and as a Web interface procedure.
CLI: Enabling SNMP Trap
This example shows how to send SNMP trap to the SNMP server.
(Netgear switch) #config
(Netgear switch) (Config)# snmptrap public 10.100.5.17
(Netgear switch) (Config)#snmp-server traps linkmode
when link status changes.
Web Interface: Enabling SNMP Trap
To use the Web interface to add a new community, proceed as follows:
1.
Enable send SNMP trap to the server 10.100.5.17.
a.
From the main menu, select System > SNMP>SNMP V1/V2>Trap Configuration. A screen
similar to the following displays.
Figure 21-2
b. In the Community Name field, enter public.
c.
Select SNMPv1 from the Version pull-down menu.
21-2
Enable send trap to SNMP server 10.100.5.17
Enable send link status to the SNMP server
v1.0, November 2008
SNMP