Table of Contents
Advertisement
a.
From the main menu, select Routing > Advanced >IP Interface Configuration. A screen similar to
the following displays.
Figure 8-4
b. Under IP Interface Configuration, scroll down to interface 1/0/3 and select the checkbox for that
interface. 1/0/3 now appears in the Interface field at the top.
c.
Under the IP Interface Configuration, enter the following information.
•
In the IP Address field, enter 192.150.3.1.
•
In the Subnet Mask, enter 255.255.255.0.
•
Select Enable from Routing Mode pull-down menu.
d. Click Apply to save the settings.
Enable RIP for the Switch
Note: This step can be skipped since the RIP is enabled by default.
Routing Information Protocol
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
8-5
Advertisement
Table of Contents
