Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Configure a One-Way Access Using a TCP Flag in an ACL
This example shows how to set up one-way web access using a TCP flag in an ACL. PC1 can access FTP
server1 and FTP server2 but PC2 only access FTP server2.
Port 0/13
192.168.100.2
FTP Server 1
Layer 2 Switch
Port 0/35
PC 1
Figure 12-7
CLI: Configuring a One-Way Access Using a TCP Flag in an ACL
To use the CLI to configure the GSM7248R, enter the following CLI commands:
Step 1: Configure the GSM7248R (see
Create VLAN 30 with port 0/35 and assign IP address 192.168.30.1/24.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 30
(Netgear Switch) (Vlan)#vlan routing 30
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 0/35
(Netgear Switch) (Interface 0/35)#vlan pvid 30
(Netgear Switch) (Interface 0/35)#vlan participation include 30
(Netgear Switch) (Interface 0/35)#exit
12-8
Port 1/0/48
Port 0/44
Figure
v1.0, November 2008
Port 1/0/24
192.168.40.2
FTP Server 2
Layer 3 Switch
Port 1/0/25
PC 2
12-7)
Access Control Lists (ACLs)
Advertisement
Table of Contents
