•
In the Network Mask field, enter 255.255.0.0.
•
Select Enable from the pull-down menu.
d. Click Apply to save the settings.
3.
Enable VRRP on the 1/0/4.
a.
From the main menu, select Routing > VRRP > Basic> VRRP Configuration. A screen similar to
the following displays.
Figure 11-7
b. Under Global Configuration, next to the Admin Mode, select Enable radio button.
c.
Enter the following information in the Virtual Router Configuration:
•
In the VRID(1 to 255) field, enter 20.
•
Select 1/0/4 from the Interface pull-down menu.
•
In the Priority(1 to 255), enter 254.
•
In the Primary IP Address, enter 192.150.2.1.
•
Select Active from the Status pull-down menu.
d. Click Add to save the settings.
Virtual Router Redundancy Protocol
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
11-7