Expansion Module Information; External Data Locations Information - Cisco CTS-500 Configuration Manual

Configuring the Cisco Unified IP Phone

Expansion Module Information

Table 2-4
Configuration page. Leave all fields unchanged.
Table 2-4
Field
Module 1
Module 1 Load Name
Module 2
Module 2 Load Name

External Data Locations Information

Define the server locations for external data using the information in
Observe the Following:
•
If a server hostname is used, it must be resolvable by the Cisco Unified IP Phone 7975.
Note
•
•
For information about configuring the phone with Cisco Unified CM firmware release 8.0, see
Note
"Configuring the MIDlets IP Phone Interface" section on page
Be careful when typing URLs to avoid typos.
Note
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
2-8
describes fields found in the Expansion Module Information section on the Phone
Expansion Module Information
The server designation can be either the IP address or the hostname of the Cisco TelePresence
device.
The format for each required field is http://server hostname: or IP address: Followed by the 8080
port address, then a slash and one of the following, depending on the field:
– services.html
– getservicesmenu.jsp
– authenticate.html
idle.html
–
Leave fields in the External Data Locations Information table blank to use the default settings.
Chapter 2 Configuring the Cisco Unified IP Phone for MIDlets
Required? Setting
— <None>
— Leave blank.
— <None>
— Leave blank.
Table 2-6 as a guide.
2-17.
OL-21851-01