Cisco CTS-500 Configuration Manual page 136

Peripheral Status Messages
Table A-3 Peripheral Status (continued)
Notification
CtpPeripheralStatusCode
ctpEtherPeripheralStatus—
Information about a single peripheral
attached through an ethernet port.
ctpEtherPeripheralStatusEntry
•
ctpEtherPeripheralIndex
•
ctpEtherPeripheralIfIndex
•
ctpEtherPeripheralAddrType
•
• ctpEtherPeripheralAddr
ctpHDMIPeripheralStatus—
Information about a single peripheral
attached through the HDMI port.
ctpHDMIPeripheralStatusTable
•
ctpHDMIPeripheralStatusEntry
•
ctpHDMIPeripheralIndex
•
ctpHDMIPeripheralCableStatus
•
• ctpHDMIPeripheralPowerStatus
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
A-6
Appendix A MIBs, RFCs, and SNMP Trap Messages for the Cisco TelePresence System
Return Values
commError
•
noError (0)—Expected peripheral device is functioning through the attached
•
port.
other (1)—None of the states listed.
•
cableError (2)—Expected peripheral device has a cabling issue.
•
• powerError (3)—Expected peripheral device has a power issue.
• mgmtSysConfigError (4)—Expected peripheral device has a communications
management system configuration issue.
• systemError (5)—Cisco Telepresence system error.
• deviceError (6)—Expected peripheral device is attached but is not fully
functional.
linkError (7)—Expected peripheral device has a port level link issue.
•
Example
CISCO-TELEPRESENCE-MIB::ctpEtherPeripheralIfIndex.1.1 = INTEGER: 7
CISCO-TELEPRESENCE-MIB::ctpEtherPeripheralAddrType.1.1 = INTEGER: ipv4(1)
CISCO-TELEPRESENCE-MIB::ctpEtherPeripheralAddr.1.1 = STRING:
"10.16.123.4"
CISCO-TELEPRESENCE-MIB::ctpEtherPeripheralStatus.1.1 = INTEGER:
noError(0)
Cable
• plugged (1)—Peripheral cable is plugged.
• loose (2)—Peripheral cable is loose.
unplugged (3)—Peripheral cable is unplugged.
•
unknown (4)—Cannot detect peripheral cable status.
•
internalError(5)—Internal error.
•
Power
• on (1)—Peripheral power is on.
• standby (2)—Peripheral power is in standby mode.
• off (3)—Peripheral power is off.
• unknown (4)—Cannot detect peripheral power status.
• internalError (5)—Internal error.
Example
CISCO-TELEPRESENCE-MIB::ctpHDMIPeripheralCableStatus.3.1 = INTEGER:
plugged(1)
CISCO-TELEPRESENCE-MIB::ctpHDMIPeripheralPowerStatus.4.1 = INTEGER:
standby(2)
CISCO-TELEPRESENCE-MIB::ctpHDMIPeripheralPowerStatus.7.1 = INTEGER:
off(3)
OL-21851-01