Cisco CTS-500 Configuration Manual page 162

Contents
Table C-1 Product Specific Configuration Fields
Detect Unified CM
Yes
Connection Failure
Minimum Ring Volume
Yes
Handset/Headset Yes
Monitor
Enbloc Dialing
Yes
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
C-6
Normal Determines the sensitivity that the phone has for detecting a connection failure
to Cisco Unified Communications Manager (Cisco Unified CM), which is the
first step before device failover to a backup Cisco Unified CM/SRST occurs.
Valid values specify Normal (detection of a Cisco Unified CM connection
failure occurs at the standard system rate) or Delayed (detection of a
Cisco Unified CM connection failover occurs approximately four times slower
than Normal).
For faster recognition of a Cisco Unified CM connection failure, choose
Normal. If you prefer failover to be delayed slightly to give the connection the
opportunity to reestablish, choose Delayed. Note that the precise time
difference between Normal and Delayed connection failure detection depends
on many variables that are constantly changing.
0 (silent) Controls the minimum ring volume on an IP phone. This value is set by the
administrator, and can not be changed by an end user. The end user can
increase the ring volume, but may not decrease the ring volume below the level
defined. The minimum ring volume range is from 0 to 15, with 0 (silent) being
the default value.
Enabled When handset/headset monitoring is enabled, a supervisor can pick up the
inactive handset/headset and hear the call in progress. For example, if an agent
is on a call on the headset, a supervisor can hear the other party on the handset.
Only the microphone on the active handset/headset is in use. For example, if
an agent is active on the headset, then the headset microphone is active and the
handset microphone is disabled.
Enabled "Enabled" indicates that the phone will use
the entire number is known at dial time. "Disabled" indicates that the phone
will use "Overlap" dialing (one digit at a time).
Appendix C Product Specific Configuration Layout Help
enbloc dialing (all at once) when
OL-13677-05