Assigning A Directory Number For The Shared-Line Cisco Unified Ip Phone - Cisco CTS-500 Configuration Manual

Assigning a Directory Number for the Shared-Line Cisco Unified IP Phone

Assigning a Directory Number for the Shared-Line Cisco Unified
IP Phone
To assign a directory number to a shared-line Cisco Unified IP phone, perform the following tasks using
the Cisco Unified Communications Manager Administration interface.
•
•
Adding a New Directory Number
To add a new directory number, follow these steps:
Step 1 Log in to the Cisco Unified CM Administration interface.
Step 2 From the Device drop-down menu, select Phone. The Find and List Phones Page appears.
Step 3 Locate and click the highlighted Cisco Unified IP phone device that you created in the
Cisco TelePresence Device" section on page
Step 4 In the Association Information window, click Line [1] - Add a new DN. The Directory Number
Configuration window appears.
Note Use the device MAC address to help you determine which line to select. The MAC address is also used
as a device number (represented by X in this document) for the settings in the Directory Number
Configuration window.
Proceed to the
Step 5
the directory number for a shared line in the Directory Number Configuration window.
Configuring the Directory Number for a Shared Line
You must restart your system after you have completed the configuration tasks in this section.
Note
To configure the directory number for a shared line, perform the tasks in the following sections. When
you are finished configuring your settings, click Save and follow the prompts to restart the system.
•
•
•
•
•
•
•
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
1-38
Chapter 1
Adding a New Directory Number, page 1-38
Configuring the Directory Number for a Shared Line, page 1-38
"Configuring the Directory Number for a Shared Line" section on page 1-38
Directory Number Information, page 1-39
Directory Number Settings, page 1-39
Call Forward and Call Pickup Settings, page 1-39
MLPP Information, page 1-40
Line X on Device X, page 1-40
Multiple Call/Call Waiting Settings on Device X, page 1-40
Forwarded Call Information Display on Device X, page 1-40
Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
1-4. The Association Information window appears.
"Adding a
to configure
OL-21851-01