Assigning A Directory Number To The Cisco Telepresence Device; Parameters Used In Phone Field - Cisco CTS-500 Configuration Manual

Assigning a Directory Number to the Cisco TelePresence Device

Table 1-13 Phone Security Profile CAPF Information
Field
Authentication Mode
Key Size (Bits)
Note These fields are related to the CAPF Information settings on the Phone Configuration page.

Parameters Used in Phone Field

To configure the Parameters Used in Phone Field, follow these steps:
Enter the SIP Phone Port information using the information in
Step 1
Click the Save button to save your settings.
Step 2
Table 1-14 Parameters Used in Phone Field
Field
SIP Phone Port
Assigning a Directory Number to the Cisco TelePresence
Device
This section describes how to assign a directory number to the Cisco TelePresence device that you just
created in the
Perform the following tasks in the Cisco Unified CM Administration interface:
•
•
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
1-30
Chapter 1
Required Setting
Yes Choices are:
•
•
•
Yes Choices are:
•
•
•
Required Setting
Yes This setting applies to SIP phones that are using UDP transport.
Enter the port number for Cisco Unified SIP IP Phones that are using UDP
to listen for SIP messages from Cisco Unified CM. The default setting
equals 5060.
Phones that are using TCP or TLS ignore this setting.
"Creating a New Cisco TelePresence Device" section on page
Configuring the Access Directory Number, page 1-31
Configuring the Directory Number for the Cisco TelePresence Device, page 1-32
Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
By Null String
By Existing Certificate (precedence to LSC)
By Existing Certificate (precedence to MIC)
512
1024
2048
Table 1-14 as a guide.
1-5.
OL-21851-01